Відео

what do you do when you pull all the fuses and the test light stays on?

If you pull off your fuel tank, just put a new fuel pump on. Or if you take off your bed, put a new fuel pump on. The access is a dream. These trucks are old, be proactive. These trucks are old.

I took my bed off by myself. I'm 5'8

THANK YOU a thousand times. This is so far the simplest, useful , and concise way to explain and help all of us with similar situations. Thank you, thank you so much and God bless you brother🙏

Saving lives out here. My fuse was not burnt out, but taking it out and putting it back fixed it all

Excellent video easy to follow thank you keep on.

It worked on my two generators that had the same problem. Thank you so much

Thank you much

My dodge 2500 doesn't have a damn filter. Mot sure what to do

Every video on transmissions doesn't show adding fluid. Another waste.

I'm only slightly confused. You don't show hooking the positive terminal back up before checking each of these fuses. So leave it disconnected and merely check the same way you did at first? Or, reconnect the battery and then check fuses? Even if you see this and answer relatively soon, I'm going to be outside trying. I definitely have issues on my Jeep because I blow fuses all the time on various lights. I really don't want to pay a shop to look at it.

jesus you have the same car and same sound problem as mine lmfao

My 96 silverado is doing the same thing. Sometimes it will start after a couple tries. And sometimes it takes a excessive amount of turning over till it sputters to life. Then it will need to idle for 10 or 20 minutes before you can give it any gas to move or it will die, and then more hard to start. It gets fule it gets fire it gets air flow. That sensor dosen't exists on my truck. So I don't know what could be the issue.

a dumb question, how can rings stick? rings wear out finally as in thickness by rubbing cyclinder walls quadtrillion times. most wear would be after extended setting times.

Unfortunately, my issue is intermittent, after I go from start to drive too quickly, or more persistent when its raining a while. also with random brake light short codes. I think it is time to start tracing wires for moisture perhaps?

👎

Put new carb on 89 kawasaki bayuo and wont run with choke off ??

What if ypu pull every single fuse and the light never goes out?

Awesome video, made my day. For weeks my brake was squeeking. Couldnt figure out why. This fixed the problem 😁

Thanks

And how do you test if a 02 sensor is bad or not due to a P0141 engine code?

Could you share the other video that you mention in the video that you have previous explain to when connecting and disconnecting the battery and performing testing?

Hey brain this is Matthew I have a 2005 jeep grand cherokee v8 4wd 4.7 my check engine light keep coming on and off every time i check 4 02 sencers

As always, enjoy Thomas Brian Can't wait for the next training video, take care 👍 CANNY, Thomas Brian From Nick Ayivor from London England UK 🇬🇧 ⏰️ 22:38PM Good Evening

As always ,enjoy Thomas Brian 👍 INTVITIVE, Thomas Brian Take care From Nick Ayivor from London England UK 🇬🇧 ⏰️ 22:33PM Good Evening

As always, enjoy Thomas Brian 👍 WHIP SMART, Thomas Brian The bottle of water is very good for your body 💧,Thomas Brian Take care From Nick Ayivor from London England UK ⏰️ 22:27PM

tried this and its still completely stuck. it wont move at all. can anyone help

And do what???? Replace it? Fix the module? You didnt explain

all i have is two cordless drills... will that still work...? 🤔 whatever, imma try it

Let me tell you, how stupid I felt typing in the problem I had thinking I would find something to fix it on youtube. Brother I can't thank you enough. I was in full-blown panic mode about an hour ago until I found your video and worked like a champ . BTW mine is a 98 305 and it was the same issue

I've hade to replace 5 fuel pumps on different vehicles, 4 of the 5 times it happened right after filling the tank. 😢

very good! thank you!

What if your relay is not shutting off and getting constant power

Thank you you're a good teacher❤❤❤

I replaced the cams sensor on my car and now it’s having struggle to start. I also replaced the crankshaft position center a few weeks before replacing the camshaft and it did the same thing at an AutoZone after that it stopped.

Thomas, I've been on UA-cam since the beginning and I've never commented. But, bro, you just saved my a$$. I struggled with this for 3 days. Got it out in 2 minutes after I found this.

Not sure if you still posting, need direction on how to prime carburetor, 2002 GMC Safari, it’s been sitting.

Is the jury still out on the question of the safety of doing this? 🙈

If you have a short to ground the fuse will-be blown

Great video! Thanks for the guidance it surely is appreciated!

is the tire jacked up in the air or sitting flat?

When you replaced it, did it fix your problem?

😂😂😂😂😂😂😂😂😂😂😂

Ford f 350 has two batteries will this work do I have to disconnect both positive

i am here 2024, man iam stuck in this am2 blown, dont know how

What if I do clean the sides and everywhere else but I still have a 1/4 throttle stumble/sputter

Wow Thomas you did very good job tahnks we learned every day thanks

Great vid, helped me solve my issue. My piston had gotten stuck. Popping the bleed valve helped getting going again so i could fully retract it for new brakes. Original brakes on there for 130k miles, which meant the rotor was trashed too.

Thank you very much for your very informative videos!! I have a 2005 Chrysler Town & Country that needs the motor mounts, shocks, etc changed. Your videos are so easy to understand and follow along!! Have a fabulous day!! 🥰❤️

I have a 96 Lexus es300 do you know where the fuel regulator is located?